Work must be started after 90 seconds from the time the Ignition switch is turned to the lock position and the negative terminal cable is discon nected from the battery. Failure to carry out service operations in the correct sequence could cause the supplemental restraint system to deploy. possibly leading to a serious accident. During removal or installation of the parts and the yellow wire harness and connector for the airbag is necessary, refer to the precautionary notices in the RS
section before performing the operation.
It causes problems such as insufficient cooling, poor fuel economy, engine overheating etc.Before removing and inspecting the electrical parts,set the ignition switch to the LOCK position.If there is not enough refrigerant in the refrigerant system oil lubrication will be insufficient and compressor burnout may occur, so take care to avoid this.If the high pressure valve is opened, refrigerant flows in the reverse direction and could cause the charging cylinder to rupture, so open and close the low pres sure valve only.If refrigerant is overcharged.
Evacuate air and charge proper amounto of purified refrigerant Bubbles in the sight glass with ambient temperatuers higher can be considered normal if cooling is sufficient.When air conditioning is turned off, refrigerant foams and then stay clear.No temperature difference between compressor inlet and outlet.Bubbles present insight glass Check for gas lakage with gas leak tester and repair if necessary Add refrigerant until bubbles disapear Check for gas leakage with gas leaktester and repair if necessary Add refrigerant until bubbles disappear Discharge refrigrant.